Support‎ > ‎

LiftExpress - MC909X Software Installation

* NOTE * You must place the 9090 into the Communications Cradle which is attached to your Lift Express PC. The PC must recognize the 9090 and start an Active Sync session.
  
1) Copy LiftExpressClient.CAB from PC Folder LiftExpressClient\WM5 to Application Folder on 9090.

2) Copy NetCFV35.WM.ARMV4I.CAB from PC Folder LiftExpressClient\WM5 to Application Folder on 9090.

3) On 9090 – Start – Programs – File Explorer – My Device – Application Folder. Launch LiftExpressClient.CAB. Choose to install it in Application.

4) On 9090 – Start – Programs – File Explorer – My Device – Application Folder. Launch NetCFV35.WM.AMV4I.CAB to install. Choose to install it in Application. Reboot Ok



5) Cold Boot 9090.
            Eject Battery, but leave in the “socket”
            Hold down the Red ON / OFF Button and press the SCAN Trigger
                        AT THE SAME TIME
            Slide the battery back into the “socket”

6) See MC9090 Setup for more steps

Comments